
Help for 'Miter'.

   In BASIC it is easy to draw a single thick line - we just divide the
  'rectangle' into two triangles and use PLOT 85.  However BASIC does
  not provide any method to join a sequence of thick lines. 

   The kinds of 'joints' usually considered are: -
      (a) Round joint, (b) Butt joint and (c) Miter joint.

   The Round joint is easy and the Butt joint is a bit harder. The miter
  joint is the most difficult - and the 'edge' cases can become unwieldy
  (the mitres can easily be very long if you use very narrow angles!).
 
   The 'Miter' program now provides this facility. It is a demo program
  for drawing thick mitered lines and there are 10 different pre-set
  widths to choose from.
   It also has a rudimentary check to prevent the user from entering most
  of the 'danger zones'. While drawing these will be indicated by the
  pointer turning from Green to Red. When the pointer is Red you will not
  be able to continue until you come out of the zone and the pointer is
  Green again.



 Mouse/Keys:

 Use <Select> to start/continue to draw a sequence of lines.
 Use <Adjust> to finish sequence as an open polygon - with squared ends.
 Use <Menu> to finish sequence as a closed polygon - with mitered ends.

 Use keyboard/keypad number keys 0-9 to choose width of line (OR '>'/'<').
 Use <W> to restore the default width (=5).

 Use Up/Down cursor keys for slight adjustments to the 'danger-zone' range.
 Use <Enter> for the default value.
 Use <S> to toggle the sound On/Off when entering/leaving a 'danger-zone'.

 Use <V> to force a vertical line.
 Use <H> to force a horizontal line.

 Use <C> to swap  'Black on White' TO 'White on Black'.
 Use <F> to Fill area under the pointer.

 Use <Space> to abort current step.
 Use <Tab> to clear screen.

 Press <Escape> to EXIT.


Copyright: R.A.Swetman